Phase change cooling applications: Engine cooling

Kiran Kumar Katta, University of Texas at El Paso

Abstract

Waste heat recovery system composed of two phase cooling system, exhaust heat exchanger, and mini-turbine has been proposed by Henry Works, Inc to generate auxiliary power via harvesting engine cooling and exhaust heat loss from heavy duty vehicles. The objective of this research is to evaluate the two phase cooling system through the engine dynamometer test and obtain initial test data for the development of the waste heat recovery system. Engine dynamometer experiment for evaluating two phase cooling has been conducted using Perkins diesel engine. During two phase cooling phase, the coolant temperature showed less than 1°C variation in the cooling path and the cylinder head temperature was more uniform than that of single phase cooling. As the saturated vapor pressure increases during two phase cooling, the cylinder head and coolant temperatures are also increased. Thus, the maximum pressure of the saturated vapor in the two phase cooling is limited by allowable cylinder head temperature that is determined by cylinder head distortion, abnormal combustion, exhaust emissions, etc. The water coolant mixed with Trifluoroethanol showed lower cylinder head temperature than pure water coolant at higher vapor pressure of the coolant. Based on the measured values in the engine dynamometer experiment, the potential power output of the proposed waste heat recovery system under the same engine operating conditions in this study proved considerable amount of power can be obtained in additional to the power output of the engine.

Subject Area

Mechanical engineering

Recommended Citation

Katta, Kiran Kumar, "Phase change cooling applications: Engine cooling" (2008). ETD Collection for University of Texas, El Paso. AAI1461156.
https://scholarworks.utep.edu/dissertations/AAI1461156

Share

COinS